Can the decorative panel lines be directly pasted onto the wall? What are the key operating points!

In the decoration process, we often use decorative panel lines. Decorative panel lines are generally made of hard, fine wood, wear-resistant, corrosion-resistant, and non splitting wood as raw materials, and are processed by mechanical or manual processing. Its advantages are green and environmentally friendly, good processing properties, good paint and coloring properties, good adhesion, strong nail force, and smooth cutting surface. The installation of decorative panel lines on the wall will make the space look more three-dimensional. How should the decorative panel lines be constructed, and are there any operational requirements!

Although it can be directly pasted onto the wall, we still need to clean the base surface before installing the decorative panel lines. Firstly, use tools such as a shovel or wire brush to remove dirt, oil stains, loose particles, etc. from the base surface where the wire corners need to be pasted, and use a damp cloth to remove dust. Next, mark the elevation line, and then, it is necessary to mix the high-strength building adhesive with clear water. The amount of mixing should not be too much at once, and can be adjusted as needed. After finishing, lay the decorative panel lines that are ready to be pasted flat, and use a shovel to evenly apply the prepared adhesive to the corner bonding area. Here, it should be noted that the adhesive should be held by hand at the corners of the adhesive line, and the adhesive should be applied according to the elevation line. Rub and press slightly, and release after one minute.

In fact, the installation of decorative panel lines is very simple, as long as one detail is included during the construction process, and the newly bonded lines should be carefully maintained to prevent collisions or water ingress.